I damaged the wire that connects to oil pressure switch (above oil filter).

One of the wires is cut.

What do I do?

1. Can I disconnect the sensor on the oil pressure switch (and live like that, or will the jet ski beep all the time?)

2. Order a whole new cable harness that leads to ECU (sounds like a lot of work disconnecting all sensors to install such new harness)?


3. Can I splice the wire and solder it?

(It was disappointing to trace the oil pressure switch sensor back to the ECU and realize that I cannot just replace the 2-wire harness. The ECU has one big, fat connector and all wires/sensors connect to it. That stinks. SO, if you damage one wire or connector/sensor, you are stuck with replacing the whole harness for ALL connectors)


kauferlie
View Public Profile
Send a private message to kauferlie
Find More Posts by kauferlie




« Previous Thread