Just wondering if anybody lives in North Carolina and would be willing to help with some mod work?

Thanks

... or how about, anybody in snow country want to come south to play a little golf?

Anyway what kind of mods are you interested in doing? The forum might be able to help.

Philip

i am interested in the Fercho jet mod if it would be applicable to my IR stage 1 boat. I am a little hesitant as to being able to do this mod on my own and not messing up my boat.

any ideas? or anybody in NC that can help me out with this?

CARL DOES IT ALL.

If in doubt contact him!!! He'll hook you up!!

Where you at MPower?

Blaster94

i am in Raleigh...so rather close to you. what kind of boat/boats do you have and what mods?

Mpower dont you have a place on kerr lake? did you make the boat race's the other week end?

kman2

i am actually on lake Gaston.. (same area though)..what boat races are you referring to? you wouldnt happen to be willing to lend a hand with doing some mods would you?

maybe there are some bolt on mods you could do (that might even be better than doing the jetworks mod)

something like
- rejet carbs and add F/As (1 to 2 mph)
- raise compression (1 to 2 mph)
- swap 13/19 for Nujet 6.5 (1 to 2 mph)

on the carbs, you could ship the rack to Carl and he will set them up for you (that is what I did 3 years ago!)

Philip

so if i were to add those 3 mods i would be looking at 3-6 mph increase in top speed? how much better would holeshot be? how much would those 3 mods run me? and finally could i add those 3 mods without any other mods such as something like the free flow kit?

thanks philip

Kman2 I am the one who has a 2nd home on Kerr lake and race offshore boats for Fountain. Mpower I may have some time over the winter to help you with your mods Email 2fast4u1@msn.com

Ok so the point of my post was that there might be some simpler mods other than the Jetworks mod that you might consider

since most of us are focussed on going faster I suggested mods that would do that - jetting, F/As and raise compression will also improve holeshot - Nujet is a better mid and high than 13/19 (13/19 will have a better holeshot)

sell your 13/19 and buy Nujet 6.5 - net cost $25 to $75

raise compression - new head $300 - used head $200

jetting $100 - F/As $200

only if you raise the compression would I say you consider a free flow, so depending on what compression you go to and what octane fuel you use you might get away with not adding a free flow (if compression is low and octane is high than maybe no free flow is needed)

I would think if you did all 3 mods you would have a 69-70 mph ski

oops ..Too much freash air and i cant think straight.2fast did you make the race's the other week end on kerr.First time in like 50 years ,hope they do it again.Mpower i havnt really done too much with the gpr's.But if you need some help,i can turn a wrench.Kman064@aol.com I have some weekends free,fishing for those stripers now.